Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
I finally got around to posting some pictures on flickr of my first board I built last week. Took me about 6 hours of hand soldering everything.
Would you be able to post the schismatics for your jtag unit
thank you
Read this post:
http://proxmark.org/forum/viewtopic.php?id=149
Did you try this? It's from the manual.
Pins 3, 4 and 5 are the same.
http://i39.tinypic.com/2vsniae.jpg
I'd tried it but didn't work too!
Try to check your cable make sure you have the correct pins.
Pin 1 referenced below:
Parallel port 3 -> Pin 7 Prox
Parallel port 4 -> Pin 9 Prox
Parallel port 5 -> Pin 5 Prox
Parallel port 11 -> Pin 13 Prox
Parallel port 18-25 -> Pins 4,6,8,10,12,14,16,18,20 Prox
Also try a different computer or try changing the parallel port setting within your BIOS.
I got mine to work in ECP mode even thought the documentation says not to use it.
Hope this helps!
Last edited by n0t (2009-03-04 14:10:22)