Proxmark3 community

Research, development and trades concerning the powerful Proxmark3 device.

Remember; sharing is caring. Bring something back to the community.


"Learn the tools of the trade the hard way." +Fravia

  • Logged in as ikarus
  • Last visit: Today 11:22:42

Announcement

Time changes and with it the technology
Proxmark3 @ discord

Users of this forum, please be aware that information stored on this site is not private.

#1 2010-10-04 12:20:04

notserpe
Member
From: Montreal
Registered: 2009-09-15
Posts: 14
Website

Read the value for MAINF?

If you have JTAG set up for your board, would you mind posting the value you get for MAINF when you read CKGR_MCFR?
This can be done simply with the target halted from the openocd jtag telnet command line with:

mdw 0xfffffc24

My ZikZak PM3 reports a MAINF of 16,594,000. I'm trying to understand if the crystal is really way off or if this is a error related to how the AT91SAM7S counts the freq over 16 slow clock cycles. Unfortunately, I don't have scope handy. Ideally you would read your MAINF
from the register and measure the on-board 16Mhz crystal with a scope.

Thanks in advance

Last edited by notserpe (2010-10-04 12:22:21)

Offline

#2 2013-11-21 08:49:10

holiman
Contributor
Registered: 2013-05-03
Posts: 566

Re: Read the value for MAINF?

@rabi, perhaps you posted to the wrong topic? "Gone in 360 seconds" was done by Roel Verdult, his forum name is "rule"

Offline

Quick reply

Write your message and submit

Board footer

Powered by FluxBB