Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Hi, I have some weird issue. Couple of days ago I flashed my proxmark with Iceman's fork. Everything was fine until I wanted to use "hf se" on my iclass card. This command works like on 1/50 attempts. This very same card was recognized 100% of the time before flashing the firmware. I can't belive that this behaviour is caused by flashing FW, because I returned to previous one and there is the same problem.
It happens only for:
Mem: 16 KBits/16 App Areas (255 * 8 bytes) [1F]
Always works for:
Mem: 2 KBits/2 App Areas (31 * 8 bytes) [1F]
Any idea?
Last edited by Wyjec (2018-12-12 21:08:30)
Ok, I noticed, that my company started to change our access control system cards. They're look the same as the old one, but Proxmark can't recognize them. Are there any new iclass cards, that aren't even recognizable by Proxmark?
Ok, I noticed, that my company started to change our access control system cards. They're look the same as the old one, but Proxmark can't recognize them. Are there any new iclass cards, that aren't even recognizable by Proxmark?
Maybe Seos? Not sure if that has been added yet...