Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Hi
How does the LF Antenna on the PM3 Easy connect to the main circuit board?
I can't see any obvious connectors.
Have looked and cannot find any references.
Thanks in advance
Last edited by Spyder (2018-10-02 18:18:37)
The LF antenna connects through two of the metal screws / posts. Specifically, the pair of them in the middle of the Easy main board. On the antenna board, it's the two that are opposite where the USB connector are. There maybe a couple little 'arrows' or chevrons on the antenna board pointing to the two screws in question.
Thanks
See Hardware 125kHz Antenna Section for solution.
http://www.proxmark.org/forum/viewtopic.php?id=6008
Last edited by Spyder (2018-10-02 19:15:14)