Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Hello all,
A small new problem came to my attention when I tried to upgrade the firware.
I am under linux and I used :
./flasher /dev/ttyACM0 ../armsrc/obj/fullimage.elf
Loading ELF file '../armsrc/obj/fullimage.elf'...
Loading usable ELF segments:
0: V 0x00102000 P 0x00102000 (0x0002ccd8->0x0002ccd8) [R X] @0x94
1: V 0x00200000 P 0x0012ecd8 (0x00001930->0x00001930) [RW ] @0x2cd6c
Note: Extending previous segment from 0x2ccd8 to 0x2e608 bytes
Waiting for Proxmark to appear on /dev/ttyACM0. Found.
Entering bootloader...
(Press and release the button only to abort)
Waiting for Proxmark to reappear on /dev/ttyACM0....... Found.
Flashing...
Writing segments for file: ../armsrc/obj/fullimage.elf
0x00102000..0x00130607 [0x2e608 / 372 blocks].....................................................After that the proxmark kept stuck, nothing is happening anymore and my leds A and C are lit (not flashing just lit)
And by looking in the usb I see the proxmark but when I go to the port it say invalid port.
So basically cannot access my proxmakr anymore
Is there anything I can do ?
Thank you in advance
Last edited by T. (2018-05-13 15:13:29)
Hi T.
Iam facing the exact same issue. Stuck at the flashing step just like you.
I just tried to run the flash again, and Iam now stock in the previous step "Waiting for Proxmark to appear on /dev/ttyACM0. Found." just before entering the bootloader.
I followed all the github step and unfortunately, it didnt sucess...
https://github.com/Proxmark/proxmark3/wiki/Kali-Linux