Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Hello,
I bought Proxmark with original firmware from 3.1.2009 (bootrom.s19 and osimage.s19).
Few days ago I downloaded pm3-20090603-r29 and flashed bootrom.s19, osimage.s19 and fpgaimage.s19.
System stopped working - after booting - red led was shining, and I had to restore the original firmware from 3.1.2009.
I revealed that the problematic firmware is fpgaimage.s19, when I flashed only bootrom.s19 and osimage.s19 everything works without problem.
The same behaviour has the recent version pm3-20090713-r52, when I flash bootrom.s19 and osimage.s19, everything works, but when I try to flash fpgaimage.s19 (using prox fpga fpgaimage.s19) system stops working and I need to restore firmware from 3.1.2009.
So at this time, I use fpga firmware (probably from 3.1.2009 firmware) and bootrom and osimage from pm3-20090713-r52, and it seems working.
Where is a problem?
Thanks for explanation,
Pavol
I was just doing some code development this evening and came across a similar issue where flashing updated code to the PM3 seemed to break it. It wouldn't boot or be recognized by the PC. Reflashing earlier code would fix it. Initially I suspected my code changes were breaking it but this wasn't the case here as adding some dummy code (like duplicate an existing function) would make the problem go away.
I haven't gotten to the bottom of it yet but I have a hunch that there is a bug in the bootloader FLASH code where it fails to write the last page of the s19 file if it doesn't end on a 256 byte boundary. Just be warned for now. I'll look into this when I have some spare time unless someone wants to beat me to it and analyse the boot flash code.
d18, when you said you were able to reflash earlier code, I assume you didn't flash over the bootrom so that you didn't need a JTAG?
I'm on a 128k chip and definitely went over 128k when writing.