Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
Pages: 1
Thank you for your answer,
Yes I know, HackRF seems to be very good, but is there any software developed for RFID 860-960Mhz cards (cracking : ISO18000-6C EPC G2 & ISO18000-6B) for any of these devices you mentioned?
Regards
Not that I'm aware of but I have not been looking.
If it is a matter of a simple replay attack (I doubt it will be) you can record and play back tags no worries at all. I have done this at 125kHz.
Well it is a relatively cheap equipment and also provides a very portable solution (hardware+software). Remember that if you want to interact with non-blank UHF tags usually (hopefully) a non-default-password is set so, unless you are also able to sniff a communication, you can't do so much even with the above hardware+software.
If you want to study how UHF works (command layer) you can use the "HF-way" testing (with a pm3 or other HF product) some ISO15693 tags that have quite a lot common things with UHF stuff (look for texas instruments tag-it products). After you will be confident with them maybe you will buy a real UHF hardware or maybe you will desist
Last edited by asper (2014-04-01 10:20:25)
Well,
I have one existing UHF card on system that I want to clone(probably password protected) or use MINI ME software for relay attack(I can sniff traffic without problem). Problem is that there is no software for UHF sniff attacks(this one that comes with MINI ME seems not to be suitable for relay attrack)?
Regards
http://rfidshop.com.hk/ -- Here you can find software
Hardware on Ebay: http://www.ebay.com/itm/RFID-UHF-860-960Mhz-reader-writer-6-meter-NXP-Chip-SDK-Inlays-RS232-/291077993984?pt=US_Surveillance_Accessories&hash=item43c599b600
Price is about 220$ which is expensive.
Last edited by gdadic (2014-04-01 14:39:06)
If you refer to this sentence:
read/write UHF Tag ID & Memory
sadly I inform you that it is NOT able to write/change/modify/alter an UHF Tag ID. It only means that supports Tag ID (no memory, only ID) and Tag ID which also has user memory.
Last edited by asper (2014-04-01 17:42:48)
If you are hardcore enough, you can try to design first fake UHF tag simulator yourself. You will have to find some transceiver that have same operating frequency, modulation etc as your real tag. Then connect it to microcontroller that can handle that transceiver, write the software and let us know.
Quick googling showed me Phychips PR9200 SoC and Intel's R500 transceivers.
Last edited by vivat (2014-04-04 04:34:55)