Research, development and trades concerning the powerful Proxmark3 device.
Remember; sharing is caring. Bring something back to the community.
"Learn the tools of the trade the hard way." +Fravia
Time changes and with it the technology
Proxmark3 @ discord
Users of this forum, please be aware that information stored on this site is not private.
I have a PM3 Easy that I purchased quite a while ago that has a ATMEL AT91SAM7S256 on it and I bought a ATMEL AT91SAM7S512 off of Ebay. I am going to replace the chip with the larger one. Will I be able to program the bootloader and firmware through the USB com port? Or will I need to use a JTAG programmer?
It looks like there is an easy way to use a Raspberry Pi as a JTAG programmer.
Any help would be greatly appreciated.
you need a jtag programer